ICD2 Programmer software without MPLAB

[zampar]

I found this program on the net to Program with ICD2 without MPLAB!
It´s support USB and Serial.


link
http://rapidshare.com/files/72919994/gravador_ICD2.zip.html

Best Regards,

Zampar

[50caliber]

I have been looking for something like this for a while.  Will evaluate and supply results in next few days.  It would also be nice to locate an in-circuit programmer with parallel port (or serial) output, even if an output buffer was required.  Am mostly interested in a simple way to offer remote firmware updates without MPLAB or ICD2.

[caveman508]

I would love to hear of a better interface to the MC ICD2, MPLAB is just not quite with it.  I have to use it for the current project, but this thing is TRULY "Plug and Pray".

I love Microchip, but their tools are, well, free.... You get what you pay for.

Just gotta love it.

Caveman

[8K51]

Direct download link here :
http://www.altdvb.ro/tools/ProgICD2.zip

I use it with command line within Flowcode or other compilers.
No need to launch Mplab, but Mplab must be installed for ICD2 USB drivers.

[iphone]

I use it with command line within Flowcode

Can you share the 'command line for flowcode' ?

Thanks

[8K51]

@Iphone

I choose only -P, -F parameters as seen in readme.txt.
==> see screenshot1
Flowcode3(Ahmad_k version) launch then progIcd2 with good target and hexfile.
==> see screenshot2
You can add to this command line automatic write to chip, automatic loading of icd2 firmware and automatic exit from programmer.

Command line parameters:
 -P <PIC>        ; Microcontroller name (with/without "PIC" or "P" prefix)
 -F <FileName>   ; File to programm ( *.HEX , format INHX8M,INHX16,INHX32)
 -W              ; Command: Write to PIC
 -A              ; Autoload ICD2 firmware without user confirmation
 -Q              ; Close after programming

Regards

[sheriefaly]

files to use maplap with picbasic pro

[MarcoB]

I'm usig this in Proton Pic Basic. I have only Installed MLAB, but don't use it.

This is the parameters:  -pPIC$target-device$ -F$hex-filename$ -w -q

This is teh site for information: http://www.edaboard.com/ftopic267847.html

[Nata39]

I'm usig the IC-programs, work ok